the line of wacker noise and rammers have been equipped with the wm80 engine for quite some time there have been numerous revisions to

the wm80 which might be confusing when it comes time to replace the cylinder and piston the easiest way to identify the correct

cylinder and piston kit for your engine is by using the serial number item number and revision number

this information can be found on the data tag of your rammer not on the engine if you cannot find or read the data tag

this following information will be of great help the zero zero four five 909 cylinder and piston kit fits older wm80 engines found

on older rammers such as the bs-45y the bs 52y the bs60y

the s62y and bs65y this version of the wm80 uses a muffler

that is held on by exhaust studs and secured by nuts the spark plug faces down you can also identify this engine by the

air cleaner it used a chrome oval air filter or a soup can style air filter with a clip on the cover

the zero zero nine nine three thirty six cylinder and piston kit fits older bs 50-2 and bs-60-2

rammers and the bs 500 bs 600 and bs 700 rammers the spark plug is at the top of the

cylinder the muffler is mounted to the side of the engine by the exhaust screws and a mounting bracket bolted to the bottom of the crank case revision 199

and lower uses an old style muffler revision 199 and higher uses a new style muffler

a note about the zero zero nine nine three thirty six cylinder and piston kit the zero zero nine nine three thirty six

kit revision 199 and below can be used in place of the zero zero four five 909 kit you would only need to add the

exhaust studs part number 0013507 the 0176 400 cylinder and piston kit has

improved porting for the newer bs 50-2i and bs 62i rammers other than machine serial number item

number and revision number the easiest way to identify this wm80 engine is the muffler you'll notice that it wraps

around the engine there are no shortcuts to any place

worth going dhsequipment.com your wacker noise and hearts experts