The Honda 16100-Z1D-H11 Carburetor Assembly (BE17E A) is a genuine OEM replacement built for HS928, HS1332, HSS928, and HSS1332 two-stage snow blowers. As a direct Honda OEM component, this carburetor assembly carries the exact jetting, emulsion tube geometry, and fuel metering calibration Honda specified for the BE17E A application — there is no guesswork about whether the tune matches your machine. Confirm your snow blower's model and serial number against the fitment table before ordering, as Honda does supersede carburetor assemblies at serial breaks within a model run.
Key Features
- Correct Fuel Metering — genuine OEM construction means the main jet sizing, pilot circuit, and choke plate geometry match the BE17E A specification exactly, delivering the air-fuel ratio Honda calibrated for cold-weather starting and sustained auger-drive loads
- Direct OEM Replacement — replaces the original carburetor assembly on HS928, HS1332, HSS928, and HSS1332 two-stage snow blowers using part number 16100-Z1D-H11, with no adaptation required on these units
- Serial Number Verification Recommended — Honda supersedes carburetor assemblies at production serial breaks, so cross-check your machine's serial number against the compatibility table to confirm this is the correct assembly for your unit
- Restored Cold-Start Performance — a worn or varnished carburetor causes hard starting, rich or lean running, and inconsistent engine speed under load; this assembly restores the consistent throttle response and clean idle your snow blower depends on during clearing runs
The carburetor is responsible for mixing fuel and air in the precise ratio the engine needs to run cleanly across the full throttle range. On a two-stage snow blower, where the engine must sustain steady power to drive both the auger and the impeller through varying snow conditions, consistent carburetion is critical — a lean condition causes surging and loss of clearing power, while a rich condition leads to fouled plugs, difficult restarts, and excessive fuel consumption. When a carburetor becomes clogged with varnish deposits, worn through normal use, or damaged by stale fuel, replacing it with a genuine Honda assembly is the most reliable way to restore proper engine behavior and full machine performance.
Part Details
| Part Number | 16100-Z1D-H11 |
|---|---|
| Brand | Honda |
| Part Type | Genuine OEM |
| Description | Carburetor Assembly (BE17E A) |
Compatibility & Fitment
| Name | Models | Serial Range |
|---|---|---|
| Two-Stage Snow Blower | HS928, HS1332, HSS928, HSS1332 | 1000001-2069402 |
Verify Before You Order
Fitment is machine-number and revision-specific; always confirm your model and serial number against the fitment list.
Why Buy From DHS Equipment
Every part is verified against the manufacturer's part number before it ships, so what you order is what arrives. We carry parts from leading OEM brands and our own DHS Quality Parts line of professional aftermarket components. Need help finding the right part? Our team is available to confirm compatibility whenever you need it. Orders are processed fast to keep your jobs on track. We don't just sell parts. We keep you jobsite ready.
Questions? Contact our team at [email protected] or 866-611-9369 — DHS Equipment is here to help you maintain peak performance.
