dhs.com next thing we want to do is we want to remove the four bolts and remove the cylinder uh before you remove the cylinder uh if you're not very familiar

with these engines if you're not very familiar with with two cycles uh when you go to reinstall this piston or this cylinder assembly you may not recall

which which end goes where is it the intake side over here is it the exhaust side over there so just to just to remove all that uh that D before we

remove the cylinder just take a marker this was the exhaust side of the cylinder if you want just put a little EX on your engine over here this way

when you go to reassemble it you know which way the cylinder is going because it'll install either way it's going to take a 5 mm socket

head wrench drop it down in there and remove those bolts

these are socket head bolts they sometimes have a tendency to strip especially if your socket head tool if your allen wrench is a little bit worn

these bolts are a little worn uh it's always a good idea to go ahead and replace new bolts if you're going to redo this this cylinder this way the next time it won't strip because that

head of the bolt strips while it's in the cylinder uh although it's not impossible to remove it's just not the easiest thing to remove you've got to get in

there with a drill bit and you got to drill out the head uh the bolt in order to remove the cylinder and then try to extract the

bolt so we'll loosen all these

screws and we just LIF the cylinder off the pistol