so our pin is in our plugs are in our o-ring is on straighten out the jumping

and we'll upgrade now all we've got to do we're ready to have the bottom end meet the top end

again so we'll get two bolts to start we'll catch them at the corners

and we'll try to bring this end up okay

we're not tightening these yet we're just trying to align it and keep it from falling apart on us now that the corners are

are aligned the machine's not going to topple over on us we're going to take our the next two bolts and this is where you're going to lock

tight them i'm not like tightening it because i'm going to take this apart a dozen more times for more classes uh but this is where you would lock tight your bolts

we'll type this one and start it we'll lock this one and start it

then we'll go ahead and remove these two bolts lock tight them and reinstall them now we'll have all four bolts lock tighten

and we'll go ahead and snug them up once the gap is closed

then you'll go ahead and torque them to the recommended spec every model has a different specs

so i'm not going to give you a spec on this one because somebody's going to try to use that spec on a different machine and it's not going to be correct

if you need to find out what your specifications are you could always call us be happy to look it up and tell you what it is

okay so our four bolts are in we're torqued and block heighted this section of the job is done