Push-In Plug Install Hack for your Jumping Jack Rammer

Repair & Installation · Short

Push-In Plug Install Hack for your Jumping Jack Rammer

Published May 21, 2025 Duration 1:02 Brand Wacker Neuson

About this video

Dave from DHS Equipment shows you an easy trick using a 2x4 to help install the push-in plugs on your Jumping Jack Rammer. Follow DHS Equipment for more equipment repair tips and tricks! Shop https://Stores.DHSEquipmentParts.com for all of your Diamond Product, Husqvarna CP, Multiquip, Stihl, Honda, and Wacker Neuson Parts.

Transcript

7 segments · auto-generated captions

0:01

What's going to happen is the pressure of the bellows, once we drop this pin uh past flush, the pressure of the bellows is going to slide over

0:11

this piece right here. And if it slides over it, we're not going to be able to get our plug in very easily. So, what I'll do is take my single 2 by 4,

0:21

swing this out, put a 2 by 4 right there, and then rotate this to the side. And

0:29

what it does is it'll squash the bellow down a little bit, and this way there's no pressure over here, and I can finish putting the pin in

0:40

without worrying about this sliding up uh and covering it up. Okay, we're going to drive the pin in a little bit further.

0:52

Leaving enough room for the new plug. Our second plug is going to go in right now.

1:02

Okay.