uh if you're in shop conditions where you've got a forklift or an engine hoist or some means to to lift the machine lift it from right here that's the easiest way

this way we can raise it get the weight off the bottom we can remove the pin and separate them a lot of guys don't have forklifts or motor motor lifts or hoist so we're going to

do this just like you're on a job site with no no fancy tools or anything like that so we're going to do it on the floor first thing we need to do

is lift the top get the connecting rod up here all the way to the bottom so we could separate the upper and lower and expose the pin

all we've got to do is lift up we've got to

expose the pin the pin is going to be right in here so right now if it's not exposed that

means the connecting rod is not all the way at the bottom we've got to get the connecting rod at the bottom sometimes it just takes a little persuasion if you're not hanging it from

a hoist i think we hit

this is the pin right in here that pin needs to be removed along with the plugs